– Available for BMW e30, e36 and e46.

This kit includes:
– 2 x Adjustable lower control arms.
– 2 x Hub add-ons.
– 2 x Adjustable outer tie rods.
– 2 x Camber/Caster adjustable suspension top mounts.
– 2 x Adjustable lower control arm rear mounts.
– Full hardware including uniball rod ends, bolts, misalignment spacers.

Parts that this kit replaces on your vehicle :
– Lower control arms.
– Tie rods and tie rod ends.
– Suspension top mounts.
– LCA bushings.

Kit features:
– Very wide range of adjustability
– From 65 to 70 degrees of steering angle!
– The steering angle depends on the wheel/tire/spacers combination.

Lower control arms design provides correct geometry which leads to a drastic tension reduction in the suspension components.

Adjustable lock stops in both directions.
Hub add-ons brings the front roll center up on lowered cars ( 34mm roll-center correction).
Faster steering ratio. Less than 3 turns from lock- to lock at 65 degrees of steering angle.

Corrected Ackermann geometry – Ackermann value is close to 0 , which helps gaining and maintaining speed throughout cornes.

Uniball rod ends and spherical bearings :
– Thicker body for increased tensile.
– High radial load capability.
– Metal to metal support for heavy shock loads.

Recommended alignment parameters :
Toe in/out – 0
Camber – up to -4
Caster – up to 5
Tip : Before you start with toe alignment , make sure you centered the steering rack!

Wider fenders/fender flares needed with this kit.
Tire diameter NOT bigger than 620mm!

– FOR MOTORSPORT USE ONLY!

* Installation should only be performed by a qualified car mechanic!